Honda Odyssey Service Manual: Sliding Door Assembly

Honda Odyssey Service Manual / Body / Doors and Enclosures / Doors / Sliding Door Assembly

Sliding Door Position Adjustment

NOTE: If equipped, make sure to disable the power sliding door by turning the power sliding door main switch off.

  1. Place the vehicle on a firm, level surface when adjusting the doors.

  1. Remove the bolts (A), and remove both female guides (B) from the body.

    2. BA6 x 1.0 mm7.4 N·m(0.75 kgf·m, 5.4 lbf·ft)BA6 x 1.0 mm7.4 N·m(0.75 kgf·m, 5.4 lbf·ft)
    Sliding Door Latch Remote Control Assembly Replacement

    Vertical Adjustment at the Front

    See More:

    Honda Odyssey Service Manual > Front Damper/Spring Removal and Installation: Removal
    Raise and support the vehicle. Remove the front wheel. Remove the wire guide rubber (A) and the clip (B) from the damper (C). Do not disconnect the wheel speed sensor connector. 8 x 1.25 mmABCD Remove the brake hose bracket (D) from the damper. Remove the flange nut (A), while holding the joint pin ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0098