Honda Odyssey Service Manual: Zone Selection

  1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

  1. Make sure the center display is in the main screen of any function.

  1. Press and hold the ENTER on the center switch panel for about 5 seconds. The center display shows the Compass settings main menu.

  2. BACK buttonINTERFACE DIAL (press: ENTER)CENTER SWITCH PANELCENTER DISPLAY UNIT
  3. Rotate the interface dial to select the Zone Adjust, and press the interface dial to enter the selection.

    NOTE: If necessary, press the BACK button to return to the previous display.

  1. The display shows the currently selected zone number between from 1 to 15. Find the zone for your area on the zone map. If the correct zone is not shown, turn the interface dial to cycle the zone lists up or down.

  2. Zone Map

  3. Press the interface dial to decide the selected zone. Returning to the Compass Settings main menu, press the BACK button to end the zone selection mode.


    Electrical Compass Unit Removal/Installation

    Calibration

    See More:

    Honda Odyssey Service Manual > Seats: Front Passenger's Power Seat Adjustment Switch Test/Replacement
    Front Passenger's Seat NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing. Remove the front passenger's seat recline cover. Disconnect the 12P connector from the power seat adjustment switch ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0137