Honda Odyssey Service Manual: Side Impact Sensor (Second) Replacement

Honda Odyssey Service Manual / Body / Restraints / Restraints Control / Crash Sensors / Side Impact Sensor (Second) Replacement

Removal

  1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

  1. Remove the sliding door sill trim.

  1. Disconnect the side impact sensor (second) 2P connector (A) on the left or right wire harness.

    2. ABC

  2. Remove the TORX bolt (B) using a TORX T30 bit, then remove the side impact sensor (second) (C).


Installation

  1. Install the side impact sensor (second) (A) with the new TORX bolt (B) using a TORX T30 bit, and tighten the TORX bolt to the specified torque.

    2. ACB11 N·m (1.1 kgf·m, 8 lbf·ft)Replace.

  2. Connect the side impact sensor (second) 2P connector (C) on the left or right wire harness.

  3. Do the battery terminal reconnection procedure.

  4. Clear any DTCs with the HDS.

  5. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

  6. Install the sliding door sill trim.

    Rear Safing Sensor Replacement

    Side Impact Sensor (Third) Replacement

    See More:

    Honda Odyssey Owners Manual > Before Driving: Maximum Load Limit
    The maximum load for your vehicle is 1,340 lbs (608 kg). See Tire and Loading Information label attached to the driver's doorjamb. This figure includes the total weight of all occupants, cargo, and accessories, and the tongue load if you are towing a trailer. Steps for Determining Correct Load Limit ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0132