Honda Odyssey Service Manual: Washer Motor/Reservoir Replacement

Honda Odyssey Service Manual / Body / Wipers, Washers / Washer Motor/Reservoir Replacement

  1. Remove the right front inner fender.

  1. Disconnect the 2P connector(s) (A) from the windshield washer motor (B) and the washer fluid level switch (C) (Canada models).

    Washer Reservoir Capacity:

    2.5 L (2.64 US qt): USA models

    4.5 L (4.76 US qt): Canada models

    2. USA models

    ABDD

    Canada models

    ABDDAC

  2. Disconnect the washer tube (D), then if necessary, remove the washer motor and the washer fluid level switch (Canada models).

    NOTE: Fluid may flow out of the opening.

  1. Remove the clip (A) and two bolts (B) from the washer reservoir (C).

    2. ACB9.4 N·m (0.96 kgf·m, 6.9 lbf·ft)

  2. Install the washer reservoir in the reverse order of removal. Check the washer motor operation.

    Wipers/Washers System Description

    Wiper Motor Replacement

    See More:

    Honda Odyssey Service Manual > Alternator Overhaul: Alternator Reassembly
    If you removed the OAD pulley, install it. Remove any grease or any oil from the slip rings. Put the rear housing assembly and the drive-end housing/rotor assembly together, tighten the four through bolts. Push the brushes (A) in, then insert a pin or drill bit (B) (about 1.6 mm (1/16 in) diameter) ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0095