Honda Odyssey Service Manual: Brake Hose and Line Inspection

Honda Odyssey Service Manual / Chassis / Brakes / Hydraulic Brakes / Brake Hose and Line Inspection

  1. Inspect the brake hoses for damage, deterioration, leaks, interference, and twisting.

  1. Check the brake lines for damage, rusting, and leaks. Also check for bent brake lines.

  1. Check for leaks at hose and line joints and connections, and retighten if necessary.

  1. Check the master cylinder and the VSA modulator-control unit for damage and leaks.

    Connection Point

    Component

    Connected to

    Specified Torque

    Note

    A

    Front brake caliper

    Brake hose

    35 N·m (3.6 kgf·m, 26 lbf·ft)

    Banjo bolt

    Bleed screw

    8.5 N·m (0.87 kgf·m, 6.3 lbf·ft)

    B

    Rear brake caliper

    Brake hose

    35 N·m (3.6 kgf·m, 26 lbf·ft)

    Banjo bolt

    Bleed screw

    8.3 N·m (0.85 kgf·m, 6.1 lbf·ft)

    C

    Brake hose

    Brake line

    15 N·m (1.5 kgf·m, 11 lbf·ft)

    Flare nut

    D

    Master cylinder

    Brake line

    22 N·m (2.2 kgf·m, 16 lbf·ft)

    Flare nut

    E

    VSA modulator-control unit

    Brake line (12 mm nut)

    22 N·m (2.2 kgf·m, 16 lbf·ft)

    Flare nut

    Brake line (10 mm nut)

    15 N·m (1.5 kgf·m, 11 lbf·ft)

    Flare nut

    2. AABBCCEDC
    Rear

    Brake Master Cylinder Inspection

    See More:

    Honda Odyssey Service Manual > Brake Control and Vehicle Dynamics: Suspension Stroke Sensor Replacement
    Raise the vehicle, make sure it is securely supported. Disconnect the 3P connector (A) from the suspension stroke sensor (B). Front ABDo not disassemble.D9.4 N?m (0.96 kgf?m, 6.9 lbf?ft)Replace.C Rear A9.4 N?m (0.96 kgf?m, 6.9 lbf?ft)Do not disassemble.BCD Remove the bolt(s) (C) and the nut (D), the ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2023 Copyright www.hodyssey.net
    0.0121