Honda Odyssey Service Manual: Removal

Honda Odyssey Service Manual / Chassis / Brake Control and Vehicle Dynamics / VSA Modulator-Control Unit Removal and Installation / Removal

  1. Turn the ignition switch to LOCK (0).

  1. Remove the air cleaner.

  1. Disconnect the 10 mm brake lines (A) and the 12 mm brake lines (B) from the VSA modulator-control unit (C).

    2. CA10 x 1.0 mmB12 x 1.0 mmA10 x 1.0 mm

  1. Disconnect the VSA modulator-control unit 32P   connector (A) by pushing the lock (B) and pulling up the lever (C); the connector disconnects itself.

    2. ABC

  1. Remove the VSA modulator-control unit bracket mounting bolts (A), then remove the VSA modulator-control unit (B) with the bracket (C) from the body.

    2. CA6 x 1.0 mmA6 x 1.0 mmB

  1. Remove the VSA modulator-control unit (A) from the bracket (B).

    2. AB6 x 1.0 mm6 x 1.0 mm

    VSA Modulator-Control Unit Removal and Installation

    Installation

    See More:

    Honda Odyssey Service Manual > Frame and Structure: Subframe Replacement
    Special Tools Required Subframe Alignment Pin 070AG-SJAA10S Front Subframe Torque After removing the subframe mounting bolts, the front subframe rear stiffener mounting bolts, the rear engine mounting base bracket bolts, and the steering gearbox stiffener mounting bolts, be sure to replace them with ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0123