Install the VSA modulator-control unit (A) onto the bracket (B).
Install the VSA modulator-control unit (A) with the bracket (B)
to the body, then install the VSA modulator-control unit bracket
mounting bolts (C).
Align the connecting surface of the VSA modulator-control unit 32P connector (A) to the VSA modulator-control unit.
Pull down the lever (B) of the VSA modulator-control unit 32P connector, then confirm the connector is fully seated.
Connect the 10 mm brake lines and the 12 mm brake lines to the VSA modulator-control unit (A).
NOTE: The brake lines are connected to the master cylinder (B), the
left-rear (C), the right-front (D), the left-front (E), and the
right-rear (F) brake systems.
Install the air cleaner.
Bleed the brake system.
Do the VSA modulator-control unit update.
Do the VSA sensor neutral position memorization procedure.
Honda Odyssey Service Manual > HVAC: HVAC Controls
HVAC Control Unit Removal/Installation (Without Climate Control) Remove the center panel. Remove the self-tapping screws and the HVAC control unit (A). A Install the control unit in the reverse order of removal. After installation, operate the various functions to see whether it works properly. Run ...
