Honda Odyssey Service Manual: BSI Control Unit Removal/Installation

Honda Odyssey Service Manual / Electrical / Data and Communication Network / BSI Control Unit Removal/Installation

  1. Remove the left rear side trim panel.

  1. Remove the BSI control unit (A).

    1. Disconnect the BSI control unit 16P connector (B) and detach the harness clip (C).

    1. Remove the bolt.

    2. BCA9.4 N·m(0.96 kgf·m,6.9 lbf·ft)

  2. Install the BSI control unit in the reverse order of removal.

    Data and Communication Network

    Driver's Under-Dash Fuse/Relay Box (Driver's MICU) Removal and Installation (Canada model)

    See More:

    Honda Odyssey Service Manual > Secondary: Deploying Components Out of the Vehicle
    If an intact airbag or tensioner has been removed from a scrapped vehicle, or has been found defective or damaged during transit, storage, or service, it should be deployed as follows: Confirm that the deployment tool is functioning properly by following the check procedure Deploying Airbags in the ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0098